PEDICURE FILM 6940 ___IVN (6940)

ITALWAX Film Waxes are an improved version of hot wax. Due to the introduction of special components, waxes have special properties and advantages.

They work at + 42 ° С, which excludes the possibility of burns.

Wax is applied with a spatula in a thin layer, regardless of the direction of hair growth.

They clearly follow the contours of the body, because are distinguished by high plasticity, allowing you to saw through hard-to-reach areas the first time.

Due to prolonged heat exposure (5-12 seconds), waxes steam the skin well, capture every, even short and coarse hairs, and only after that they freeze.

Waxes are removed with a film, completely removing all hairs with roots, do not leave behind broken hair, irritation and redness on the skin.

Economical to use, hair can be removed from the armpit with one application. Reduce spending by about 30%.

Rules for the use of ITALWAX film wax:

1. Heat the wax in an electric heater to t + 42 ° C.
2. Treat the depilation area with an alcohol-based lotion.
3. Apply a small amount of talcum powder.
4. Apply a thin layer of wax with a spatula regardless of the direction of hair growth, but towards you, leaving a small" petal ", which you can grab onto later (we try to depilate the armpit with one application).
   

   WARNING! Apply slowly, press the spatula firmly and firmly.

5. The wax will set in 5-6 seconds (ready to remove waxshould not stick to your hand when touched).
6. Having previously pulled the skin in the opposite direction to the tear, remove the wax in a direction away from you, parallel to the skin. Repeat the procedure in the next section.
7. After depilation, treat your skin with a soothing, cooling, oil-free product: cooling cream / gel, White Orchid emulsion lotion.

Major mistakes when using film wax:

The wax stretches like caramel and doesn't come off well.

Reason: the wax did not have time to harden.

Solution: dry the wax with talcum powder, wait 2-3 seconds and remove.

There are some hairs left after removing the wax.

Cause: The wax spatula was not pressed against the skin enough, so the hairs did not get into the wax layer.

Solution: Apply wax to the area of ​​the skin with the remaining hairs, pressing the spatula closer to the depilation area.

Once removed, the wax around the edges of the applique remains on the skin.

Cause: Uneven wax application.

Solution: shape the applique with the same layer in the middle and around the edges.